30 Meter B/75- Construction and Industrial Hose
Length: 30 m
Color: outside white
Material: Outside: Polyester yarn, round woven, chain 2-ply twisted
Operating pressure: 10 bar
- with Storz suction couplings
- Wire binding
- uncoated
- Protective sleeve to prevent chafing at the hose coupling
User information:
This operating manual must be read carefully before first use and observed during use.
1. General information about flat or pressure hoses
Pressure hoses primarily serve the purpose of liquid transfer, especially water.
However, they can also be used for draining wastewater or similar. They consist of round-woven synthetic fibers (in this case polyester) and are coated inside.
A significant advantage of flat hoses is their low weight and flexibility, which makes them easy to fold and transport when not under pressure.
2. During use
Due to their primary purpose and predominant areas of use, flat hoses are subject to high external influences that can shorten their lifespan.
For optimal service life, the following is recommended:
- Do not exceed the maximum operating pressure.
- When laying out the hoses, ensure that they are rolled out (if possible). Otherwise, always pull flat. This can prevent the hose from dragging on the edge on the ground and immediately damaging the hose cover.
- Avoid rough surfaces if possible.
- Do not drag hoses over sharp, pointed objects and/or surfaces.
- Never drop hose ends or fittings, as this can lead to damage to the lugs or the fittings themselves.
- Do not pull or drag hoses under pressure on the ground, as the resulting abrasion can damage the hose cover. Vibrations of hoses under pressure can be reduced or absorbed using accessories. For example, with burlap, tarpaulins, or bandages.
- If hoses are to be used at transitions, hose bridges should be used. Hoses should never be driven over or stepped on.
- Keep hoses (if possible) away from acids, chemicals, and hazardous substances.
3. After use:
To ensure the longevity of the hoses, the following instructions should be observed after use:
- To remove the remaining amounts of the liquid medium from the hose, the hose should be lifted over the shoulder. Never step on the hose!
- After use, clean the hoses from deposits inside the hose (sand, etc.), i.e., rinse them out. They should then be dried (otherwise mold/lime can deposit inside the hose, which can permanently damage the core).
- Clean the hose cover from external dirt.
- Hoses should never be stored in a damp state.
- Check fittings for integrity.
- Store hoses (if possible) in a rolled-up state.
- When rolling up, ensure that the hoses do not drag on rough surfaces, just as when unrolling.
