1"/25mm Suction + Pressure Hose with 1" Male Hose Tail + 1" Female 2/3 Union 20m
This set consists of:
- Stainless steel - hose clamps W4 with 12 mm band width
- 2/3 brass hose fitting with hose tail
- Hose tail for clamp integration with male thread and hexagon
- Suction and pressure hose for pool, pond, agriculture, construction industry and industry
- Working pressure 6 bar
The hose complies with the REACH and RoHS regulation according to the European Directive 2007/19/EC, 10-2011 according to A-B-C.
Stainless steel - hose clamps W4 with 12 mm band width
Industry quality according to DIN 3017 with worm gear for powerful fastening.
Band and housing made of corrosion-resistant W4 stainless steel according to DIN 3017
Screw steel slot/cross and hexagon socket for secure tightening of the screw.
Details:
- Band width: 12 mm
2/3 brass hose fitting with hose tail
Details:
- Brass
- Hose tail with female thread 2-piece with union nut
- Flat sealing
Hose tail for clamp integration with male thread and hexagon
Details:
- Brass
- Male thread
- Hexagon
- Hose tail
Suction and pressure hose for pool, pond, agriculture, construction industry and industry
- Inner jacket with cast-in plastic reinforcement spiral
- Ozone, chlorine and UV resistant
- Can be used for both above-ground and underground installation
- Excellent as a suction and pressure hose in the pond and pool sector as well as a drag hose in slurry distribution, on municipal vehicles, in the printing industry, in mechanical engineering and generally in irrigation technology
- Despite excellent strong processing, light and flexible with high abrasion resistance
Basically, it is not possible to suck higher than the respective geodetic suction height, even with a lot of drive power.
The geodetic suction height is the height between the surface of the liquid and the center of the impeller/pump inlet in pumps.
Practically, it is only possible to achieve a maximum suction height of 7 to 7.50 m.
