HTsafeAM Socket with Collar DN/OD 75
This is how house drainage works today
Quick processing, secure sealing, optimal noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Deutschland
- Extremely durable
- Simple and fast processing
- Patented triple sealing lip
- Interchangeable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame retardant B1
- Approved with the most common fire protection collars from various well-known manufacturers
- Approved with our pull-out safeguards up to a maximum pressure of 2.0 bar
- Also suitable for central vacuum systems
Application:
Drainage inside buildings as wastewater pipe, rainwater pipe, ventilation pipe
(see also areas of application: DIN 1986-4).
This pipe system can be very easily installed, mounted, and laid through plug connections with sockets, inserted into the beveled pipe end (spigot side).
During installation, the pipe is pulled out by one centimeter after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it must be ensured that the wastewater does not back up or solid parts accumulate, which could block the pipe system.
A minimum slope of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3 degrees slope) to the main pipe.
The diameter of the HT drainage pipe system should be neither too small nor too large. Too large diameters reduce the sufficient floating depth of solids. Deposits and blockages could result. Too small pipe diameters bring the risk that the pipe fills completely. The resulting air closure can cause the odor trap to be sucked out. Odors from the downpipes could rise from the drain into living spaces.
HT pipes can be cut to any length with a metal or fine saw. A miter box can be used. Saw edges should be chamfered to achieve a proper connection between the HT pipe and subsequent parts. Burrs inside the pipe must also be removed to prevent damage to seals and accumulation of deposits.
Material Properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application range: -20° to 90°
- High chemical resistance; pH 2-pH 12 (acidic-basic) stable against biogenic sulfuric acid corrosion
- High abrasion resistance of polypropylene, resulting in longevity and operational safety
- Excellent impact resistance and toughness
- Low tendency to crack formation and crack propagation
- Robust behavior under mechanical stress (e.g., high-pressure cleaning)
- Smooth surfaces, optimal hydraulics
- No incrustation, deposits cannot settle
- Self-cleaning, resulting in long maintenance intervals
