HTsafe DN/OD 75
This is how house drainage works today
Quick processing, safe sealing, optimum noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable
- Easy and quick processing
- Patented 3-fold sealing lip
- Interchangeable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame retardant B1
- Approved with the most common fire protection collars of various renowned manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also suitable for central vacuum systems
Application:
Drainage inside buildings as a sewage pipe, rainwater pipe, ventilation pipe
(see also application areas: DIN 1986-4).
This pipe system can be very easily inserted, installed, assembled, and laid through push-fit connections with sockets, into the chamfered pipe end (spigot side).
During installation, the pipe is pulled out one centimeter after being completely plugged in to create an effective length compensation.
When laying the pipes and fittings, it should be noted that the wastewater does not back up, or that solid parts accumulate and clog the pipe system.
A minimum slope of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3 degrees slope) to the main pipe.
The diameter of the HT drainage pipe system should be chosen neither too small nor too large. Too large diameters reduce the sufficient floating depth of solids. Deposits and blockages could be the result. Too small pipe diameters bring the risk that the pipe fills completely. The resulting air closure can siphon off the odor trap. Odors from the downpipes could rise from the drain into living areas.
HT pipes can be cut to any length with a metal or fine saw. A miter box can be used. Saw edges should be beveled to achieve a proper connection between the HT pipe and adjacent parts. Burrs inside the pipe should also be removed to prevent damage to seals and accumulation of deposits.
Material Properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application areas: -20° to 90°
- High chemical resistance; pH 2-pH 12 (acid-base) stable against biogenic sulfuric acid corrosion
- High abrasion resistance of polypropylene, resulting in durability and operational safety
- Excellent impact resistance and toughness
- Low tendency to crack formation and crack propagation
- Robust behavior under mechanical stress (e.g. high-pressure flushing)
- Smooth surfaces, optimal hydraulics
- No incrustation, deposits cannot settle
- Self-cleaning, resulting in long maintenance intervals
