HTsafeEM Pipe DN/OD 75 x 1000 mm
This is how house drainage works today
Quick processing, secure sealing, optimal noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable!
- Simple and quick processing
- Patented triple sealing lip
- Replaceable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame retardant B1
- Approved with the most common fire protection collars from various well-known manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also for central vacuum systems
Application:
Drainage inside buildings as wastewater pipe, rainwater pipe, ventilation pipe
(see also areas of application: DIN 1986-4).
This pipe system can be very easily installed, assembled, and laid through push-fit connections with sockets, inserted into the beveled pipe end (spigot side).
During installation, the pipe is pulled out by one centimeter after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it must be ensured that the wastewater does not back up or solid parts accumulate, which could clog the pipe system.
A minimum slope of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3 degrees slope) to the main pipe.
The diameter of the HT drainage pipe system should neither be too small nor too large. Too large diameters reduce the sufficient buoyancy of solid matter. Deposits and blockages could result. Too small pipe diameters pose the risk of the pipe filling completely. The resulting air seal can cause the odor trap to be siphoned off. Odors from the downpipes could rise from the drain into living spaces.
HT pipes can be cut to any length with a metal or fine saw. A miter box can be used. Saw edges should be chamfered to achieve a proper connection between the HT pipe and adjacent parts. Burrs that form inside the pipe should also be removed to prevent damage to seals and accumulation of deposits.
Material properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application range: -20° to 90°
- High chemical resistance; pH 2-pH 12 (acidic-basic) stable against biogenic sulfuric acid corrosion
- High abrasion resistance of polypropylene, resulting in longevity and operational safety
- Excellent impact resistance and toughness
- Low tendency to crack formation and crack propagation
- Robust behavior under mechanical stress (e.g., high-pressure flushing)
- Smooth surfaces, optimal hydraulics
- No incrustation, deposits cannot settle
- Self-cleaning, resulting in long maintenance intervals
