HTsafe DN/OD 40
This is how house drainage works today
Quick processing, secure sealing, optimal noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable
- Easy and quick processing
- Patented 3-fold sealing lip
- Replaceable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame retardant B1
- Approved with the most common fire protection collars from various renowned manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also for central vacuum systems
Application:
Drainage within buildings as a waste water pipe, rainwater pipe, ventilation pipe
(see also fields of application: DIN 1986-4).
This pipe system can be very easily inserted, installed, mounted and laid through socket connections into the beveled pipe end (socket side).
During installation, the pipe is pulled out one centimeter after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it must be ensured that wastewater does not accumulate or solid parts collect, which could clog the pipe system.
A minimum slope of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3 degrees slope) to the main pipe.
The diameter of the HT drainage pipe system should be neither too small nor too large. Too large diameters reduce the adequate buoyancy of solids. This could result in deposits and blockages. Too small pipe diameters bring the risk of the pipe filling completely. The resulting air seal can cause the smell trap to be sucked out. Odors from the downpipes could rise from the drain into living areas.
HT pipes can be cut to any length with a metal or fine saw. One can use a miter box. Saw edges should be chamfered to achieve a proper connection between the HT pipe and adjacent parts. Burrs inside the pipe should also be removed so that seals are not damaged and deposits do not accumulate.
Material properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application ranges: -20° to 90°
- High chemical resistance; pH 2-pH 12 (acidic-basic) stable against biogenic sulfuric acid corrosion
- High abrasion resistance of polypropylene, thus longevity and operational safety
- Excellent impact resistance and toughness
- Low tendency to crack formation and crack propagation
- Robust behavior under mechanical stress (e.g., high-pressure flushing)
- Smooth surfaces, optimal hydraulics
- No incrustation, deposits cannot settle
- Self-cleaning, resulting in large maintenance intervals
